Parts & Service

Model OKP-BX

NOTE: For Convenience - Program Keypad BEFORE mounting.

Program Keypad for One Garage Door (CodeDodger 2)

Create Your Wireless Keypad PIN (Personal Identification Number)

On your wireless keypad:

  1. Press in order 3, 5, 7
  2. Press the PROGRAM key
  3. Enter your PIN (3 to 8 characters)
  4. Press the PROGRAM key again.
  5. Close keypad cover and wait 30 seconds

Program the keypad for a single door

On your wireless keypad:

  1. Press and hold the PROGRAM button until both LED lights turn BLUE
  2. Release button. Only the round LED will remain BLUE.
  3. Press and hold the PROGRAM button again then release. The Long LED will blink PURPLE
  4. Enter your PIN number using the keys on the keypad
  5. Press the UP/DOWN button. LEDs will stay on solid.
  6. Press the UP/DOWN button again. LEDs will turn off.
  7. Press any key to stop opener. (It will automatically stop at the fully open or fully closed position.)
  8. The keypad backlight will turn off in approximately 30 seconds.

NOTE: If the door does not move, check the LED on the keypad. If the LED is blinking rapidly, the PIN was entered incorrectly. After the LED stops blinking, re-enter your PIN ad try again. Any keypad button will control the door for 30 seconds after the door starts moving. Rapid blinking of the red LED indicates an error. After a few seconds the LED will turn off. Start over.

store

Order Parts Online

Get what you need delivered to your door.